• Cleans 3 ways with 1 spray
• Effective in 10 minutes against E. Coli 0157:H7, Methicillin-resistant Staphylococcus aureus, Influenza A2 Hong Kong (influenza) and Trichophyton mentagrophytes (Athlete's Foot Fungus).
• Disinfects, Cuts Grease, Cleans Glass
• Kills 99.9 % Germs

Ingredient List: Active Ingredients: n-Alkyl (C14-30%, C12-5%, C18-5%) Dimenthyl Benzyl Ammonium Chloride 0.05%; n-Alkyl (C12-68%, C14-32%) Dimenthyl Ethylbenzyl Ammonium Chloride 0.05%; Other Ingredients 99.90%

Warnings: Caution: Causes eye irritation. Avoid contact with eyes or clothing. Wash thoroughly with soap and water after handling. FIRST AID: If on skin or clothing: take off contaminated clothing. Rinse skin immediately with plenty of water for 15-20 minutes. IF IN EYES: hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, the continue rinsing eye. Call a Poison Control Center or doctor for treatment advice. Have the product container or label with you when calling a Poison Control Center or doctor or going for treatment. Physical or Chemical Hazards: do not use or store near heat or open flame. Storage/Disposal: Do not reuse container except with Mr. Clean Multi-Surfaces Antibacterial Spray. If not refilling, discard in trash or recycle.

Directions: DIRECTIONS FOR USE: It is a violation of Federal law to use this product in a manner inconsistent with its labeling. DIRECTIONS: 1. Turn nozzle to "ON." 2. Spray 6-8 inches from surface. 3. Wipe dry with a dry paper towel or lint free cloth to a streak-free shine. Do not breathe spray. TO SANITIZE/DISINFECT: For heavily soiled areas, a precleaning is required. For hard, nonporous surfaces, spray until thoroughly wet. TO SANITIZE: Let stand 5 minutes before wiping. TO DISINFECT: Let stand 10 minutes before wiping.

Indications: Keep out of reach of children. Precautionary Statements: Hazards to humans and domestic animals. NOTE: Is safe on most washable surfaces. However, on painted surfaces and wall coverings, test a small area before use. If applied to aluminum, wipe dry immediately. Repeated use on copper or brass may discolor these surfaces.